Radxa Zero 3W - repeat reboots - ver 0.12 and buildroot latest 3f1f50c

[rbalu72]

Hi

Thank you for sharing your hard work and this wonderful project.. I have been using aa-proxy-rs in Pi4 as well as pi02w. Pi4 with 5ghz connection is quite stable with almost no disconnects. i have kept pi02w aside as it indeed does frequent disconnects possibly due to 2.4ghz congestion etc

Recently i have bought Radxa zero 3w to predominantly take advantage of its 5ghz wifi capability and flashed release 0.12 and as well as the buildroot latest version.

my setup : tata tigor Headunit, oneplus 12 running android 15, radxa zero 3w, aa-proxy-rs version 0.12 or the latest buildroot build
3f1f50c

Issue : When powered up through usb C otg port to my car HU, all goes well and it connects within 10-15 secs and am able to open android auto interface on Car HU and initiate nagivation thru gmaps.

The connection between HU and myphone gets disconnected after say a minute or two and it tries to establish connection and connects again. This loop repeats.

I have collected logs and routed logs to write on sd card so they are for the entire session. kindly advise if anything i can do to get this working.

Many thanks
Bala

aa-proxy-rs.log

[rbalu72]

The same cable set works flawless for pi4 if that helps debug, so i keep both the devices to switch when needed.

[manio]

Thank you!
I reviewed the logs... it seems you have a power issue with the radxa, because the logs are cut in various places and it is rebooted. You can try the "Y" split cable. Radxa needs a good power supply or PD for working properly.
I also seen a lot of USB communication errors... you can also try to disable the legacy mode.

[rbalu72]

Thank you, will check and see how it goes with a Y split cable and separate psu