Lily58 keyboard keymap

Getting started

• Set up the QMK environment
  • Install QMK Toolbox
  • Install QMK MSYS
• Update keymap.c in keyboards/lily58/keymaps/oldfieldtc.
• Set the following user configs
  • qmk config user.keyboard=lily58/rev1
  • qmk config user.keymap=oldfieldtc
• Run qmk compile -kb lily58/rev1 -km oldfieldtc
• Once compiled, open QMK Toolbox and open the lily58_rev1_oldfieldtc.hex file that is found at the root of the qmk_firmware directory.
• Disconnect one keyboard half and press the reset button on the half that is connected. A Atmel DFU device connected (libusb0): Atmel Corp. ATmega32U4 (03EB:2FF4:0000) notice should appear in the window.
• Press 'Flash' and the keyboard should be flashed.
• Disconnect that keyboard half and repeat the previous two steps with the other half.
• Connect both halves together and the keyboard should now be flashed with the new keymap.

Default layer

Default layer - Keyboard layout editor

Lower layer

Lower layer - Keyboard layout editor

Raise layer

Raise layer - Keyboard layout editor

Adjust layer

Adjust layer - Keyboard layout editor